I tried to update the firmware for both the drone (Zino) and the gimbal and it seemed to 'take' both updates, but now I have no camera and also getting a "The gimbal angle sensor is abnormal" in the app, even after connecting to the Zino and I get a "Gimbal calibration failed" after trying it. I also see an "Error 0x2000" in the gimbal calibration area Compass calibration is normal and IMU (gyro) calibration is normal.
How can I correct this?
Is there a way to revert back to the previous FW versions? I don't see any of the previous versions on the Hubsan Service page. I have version ZINO_G_V3.0.2.13 installed for the gimbal and Zino_IT_V0.3.6 on the drone itself.
Flight control software shows as Zino_FC_V1.2.11
As shown in the picture below, the camera's working, but the gimbal control isn't.
![DSCF2953.JPG DSCF2953.JPG](https://dronepilots.community/data/attachments/0/225-09ea2f8225fbaad99810dde9f7537aed.jpg)
How can I correct this?
Is there a way to revert back to the previous FW versions? I don't see any of the previous versions on the Hubsan Service page. I have version ZINO_G_V3.0.2.13 installed for the gimbal and Zino_IT_V0.3.6 on the drone itself.
Flight control software shows as Zino_FC_V1.2.11
As shown in the picture below, the camera's working, but the gimbal control isn't.
![DSCF2953.JPG DSCF2953.JPG](https://dronepilots.community/data/attachments/0/225-09ea2f8225fbaad99810dde9f7537aed.jpg)
Last edited: