Blade Croma ST10+ Help

[steve s]

I need help with a blade Chroms ST10+ drone . When I turnin on the lights are solid green that change to all four white bleeking with beeping. According to Manual it’s in emergency mode & to cycle power to reinitialize. I’ve turned it off & on with no results. Any solution’s ?My control is a ST10 +

 

[GFields]

Greetings from Birmingham Alabama USA, welcome to the forum! We look forward to hearing from you!

Unfortunately, I don't know anything about the drone in question.

 

[sarahb]

Welcome!

 

[h-elsner]

Do you have an SD-card in the slot below the battery in the ST10? If yes you can connect the ST10 to PC with a micro USB cable (for Windows the ST10 be full booted up before you plug in USB otherwise no connection is possible). If you see a file system then you have an SD card. On the card the ST10 stores flightlogs. This would help to identify the problem.
Also you could record the sound, so we could try to understand what is happening.

 

[steve s]

Do you have an SD-card in the slot below the battery in the ST10? If yes you can connect the ST10 to PC with a micro USB cable (for Windows the ST10 be full booted up before you plug in USB otherwise no connection is possible). If you see a file system then you have an SD card. On the card the ST10 stores flightlogs. This would help to identify the problem.
Also you could record the sound, so we could try to understand what is happening.

The ST10 controller does not have a SD Card

 

[steve s]

There isn’t a SD card in the ST10 controller

 

[h-elsner]

You should consider using an SD card.
Did you try to connect the drone to the GUI? This is also a good possibility for diagnosis.

https://www.horizonhobby.com/on/demandware.static/Sites-horizon-us-Site/Sites-horizon-master/default/Manuals/Chroma_GUI_Downloads_10122016.pdf