i found a potensic D58, i had to buy a charging cable, i replaced batteries in the controller. i have been unable to get the drone to pair with the controller. i had it on level ground, but i can not get the the to pair. how hard is it to change out the receiver board, and can i find one?
unable to pair
- Thread starter 99AirForce
- Start date
STM
Active member
I am not sure about the D58, but if you turn on the drone first, try holding down both control sticks and then turn on the remove controller. That might fix it. It does with the Dreamer.
If the solution above doesn't work, try this- with both the drone and controller powered off, hold down the red 'lock' button and turn on the remote controller. If the remote controller makes 2 beep sounds. and the indicator light keeps flashing then the remote controller is now in pairing mode. When you turn on the drone it should automatically pair to the controller and this process won't have to be repeated. This works for the D85 so it might work for the D58.
