Eachine QX-95 Unable to Bind to Flysky FS 16x

[Barry]

Good morning. Any news?

No news so far, still unable to bind the drone. I have searched for answers, tried to set up the drone as instructed but it still does not work.

 

[DoubleG]

Have you follow also instructions in this video?

 

[Barry]

Have you follow also instructions in this video?

I just followed the steps in this video, the green slow flashing light is now a solid green light (I'm guessing its now binded). I know have a solid red light, solid green light and a slow flashing blue light.
I have tested the transmitter in the mode option in betaflight, when i move the throttle or any of the switches on the transmitter, nothing happens in betaflight. I have also tried to fly my drone and nothing happens when i do that either.

Any idea's?

Thank you agoin for your help, I feel we are getting closer.

 

[DoubleG]

May be esc are not calibrated? But I don't know how to do it...
Did you perform stick calibration on the transmitter?

 

[Barry]

Just found this on the drone, anyone know what it is or how can it help my situation?

 

[Barry]

Did you perform stick calibration on the transmitter?

No, I have no idea what that is or how to do it. I will google it and see.

 

[Barry]

Did you perform stick calibration on the transmitter?

Have done this now, didn't help. Thanks again for your help.

 

[DoubleG]

Reading several discussions about this drone, seems that the binding light is the blue one and not the green.
Red light means an error (not bind, not calibrated etc.).
My suggestion is to look for a forum most focused on this kind of drones, there you can find more skilled people.
This forum, as for what i can understand, is dedicated to commercial drones and rtf (ready to fly) ones. Infact the Eachine section is almost empty of discussions.
Sorry can't help you as you expect.

 

[Barry]

My suggestion is to look for a forum most focused on this kind of drones

Thank you DoubleG I will take a look around and see what i can find.

Thanks again for all your help.

 

[DoubleG]

Let me know if you solve and how. Good luck

 

[DoubleG]

Already looked at this video?

 

[DoubleG]

I've found another procedure :
1) switch on the transmitter in binding mode
2) bridge the pads for bind mode on the drone and connect the battery.

Make sure you bridge the "bind" pads (blue light fast blinking).