Hi, first post, I couldn't find a specific forum for the Pixhawk or Skydroid so I hope this is okay in here.
I am trying to connect a Pixhawk 6C Pro autopilot to a Skydroid R16 receiver. The manuals (which aren't very good) seem to indicate I should connect the Pixhawk 6C Pro "PPM/SBUS RC" output to the R16's "POW+SBUS" port.
I did this but get no power on the R16.
The R16 needs a minimum of 7.2v but the Pixhawk output is only around 5.2v.
Can anyone please give me some pointers on how to power the R16 receiver from the Pixhawk 6C Pro?
Do I need a Y harness with two leads from the power board into the R16 along with the SBUS from the Pixhawk?
Thanks for any help......
I am trying to connect a Pixhawk 6C Pro autopilot to a Skydroid R16 receiver. The manuals (which aren't very good) seem to indicate I should connect the Pixhawk 6C Pro "PPM/SBUS RC" output to the R16's "POW+SBUS" port.
I did this but get no power on the R16.
The R16 needs a minimum of 7.2v but the Pixhawk output is only around 5.2v.
Can anyone please give me some pointers on how to power the R16 receiver from the Pixhawk 6C Pro?
Do I need a Y harness with two leads from the power board into the R16 along with the SBUS from the Pixhawk?
Thanks for any help......
